Hebrew | Contact Us | Site Map
  • Crystal Clear IP PBX
  • Crystal Call Center
  • EZCall
  • Crystal Manager
  • Solutions for Asterisk
  • VoIP Equipment
  • CrypTone
  • Support
  • Downloads
  • Asterisk Hardware
    Sangoma A101U
    Sangoma A102U
    Sangoma A104U
    Sangoma A104D
    Sangoma A108
    Sangoma A200/REMORA


    Sangoma A102U


    The A102U is Sangoma’s next generation hardware designed for optimum support of data and voice over T1 and E1.

    Voice Modes

    • Supports Robbed Bit Channel Associated Signaling (CAS) and ISDN PRI.
    • Block mode raw bit-stream interface for integration with the Asterisk Open Source PBX/IVR platform.
    • Channelized mode supporting individual DMA into voice timeslots plus onboard HDLC support of PRI channel for soft PBX implementations that can use these features.

    Technical Specifications

    • Available as Single T1/E1 port (A101) or Dual T1/E1 port (A102) with daughterboard
    • Intelligent hardware: Downloadable Field Programmable Gate Array programming with multiple operating modes:
    • T1/E1 and fractional T1/E1, single channel HDLC per line
    • Optionally available as A101-C 0r A102-C with Channelized T1/E1 on either or both ports with any configuration of up to 64 DS0s carrying either voice or HDLC data
    • Power: 520mA at +5v
    • MTBF: > 1 Million hours (Calculated).
    • PCI 32 bit (5v and 64 bit (3.3v) compatible.
    • Temperature range: 0 - 45C.
    • All set-up and configuration is in software or by machine BIOS.
    • DSU/CSU set up entirely in software.
    • Line decoding: HDB3, AMI, B8ZS.
    • Framing: CRC4, non-CRC4, ESF, D4T1/E1.
    • Clocking mode: Normal , Master.
    • Software controlled DSU/CSU test modes.
    • Remote monitoring of card and CSU/DSU operation.
    • Dimensions: 2U Form factor: 120mm x 55 mm.

    T1/E1 Status alarms

    • ALOSV: Loss of Signal alarm
    • LOS: Receive Loss of Signal
    • ALTLOS: Alternate loss of Signal Status
    • OOF: Out of Frame
    • RED: Telco Red Alarm condition
    • AIS: Alarm Indication Signal
    • OOSMFV: Loss of Signaling Multiframe
    • OOCMFV: Loss of CRC Multiframe
    • OOOFV: Out of Off-Line Frame
    • RAIV: Receive Loss of Signal
    • YEL: Receive Telco Yellow Alarm
    • Line protocols
    • ATM, Frame Relay, X.25, HDLC, PPP, SS7, Transparent bit-stream, BSC.

    Operating systems

    • Linux (all versions, releases and distributions from 1.0 up), FreeBSD, Open BSD.

    Higher level protocols

    • IP/IPX over Frame Relay/ PPP/ HDLC/ X.25, X.25 over Frame Relay (Annex G), BSC over X.25 (DMT and TCOP), SNA over X.25, PPPoE, PPPoA, IP over ATM.

    Warranty

    • Five years parts and labour.

    Product Brochure
    Privacy Policy Copyright © 2006 , Tikalnetworks.com
    All Rights Reserved